OK a question of wiring! Here is what I know about the picture below. The terminals are labled (in the pic) A to C, and A1 to C1 for the mains voltage section and T1 and T2 for the transformer out put section. I *think* A1 in the mains neutral input, B1 being 220V active and C1 240V active. These then go to a large (650V rated switch) and from there back to the terminal block from where they, now renamed A for the neutral, B for the 220V, and C for the 240V, go to the transformer. From the transformer there are only two output wires that go to the terminal block. These are labled T1 for the neutral and T2 for 100V active. I'm assuming that the terminals stamped "0" are neutral by the way.

So have I got it right or is there something that I'm not seeing?



The picture refered to above.......



This is how and where the wires labled A to C and T1 and T2 come and go from the transformer the wire labled E is the earth wire.

I'm not totally sure about T1 and 2 they could be reversed, but the others I'm possitive about, they are as pictured and labled.



Just so ya'all can get a sense for how big this transformer is the above pic is of what's in the box, and just for scale the red box in the middle is a regular matchbox......

Back